Skip to content
← Back to theses and internships

Master's thesis

Thesis: DUV-Assisted Athermal Laser Grooving of Low-κ Dielectrics for Advanced Packaging

Fraunhofer · Aachen, Germany

Posted · Deadline: Not specified — apply early

Posted by Admin · Verified

Master's thesis at Fraunhofer: key facts

Opportunity type
Master's thesis
Organization
Fraunhofer
Location
Aachen, Germany
Field / discipline
Technology and Software, Engineering, Energy and Sustainability
Application deadline
Deadline not specified — apply early
Last source check
13 Nov 2026

About this master's thesis at Fraunhofer

In cooperation with the Chair of Laser Technology (LLT), the Fraunhofer Institute for Laser Technology (ILT)—Europe’s leading center for contract research and development in the field of laser technology—is offering the opportunity to write a thesis on the topic: »DUV-Assisted Athermal Laser Grooving of Low-κ Dielectrics for Advanced Packaging«. In advanced microelectronic packaging, low-κ dielectrics (e.g. nanoporous SiCO:H) are structured by laser grooving to reduce mechanical stress during chip dicing. State-of-the-art UV ultrashort pulsed lasers at 343 nm operate with high pulse overlap, causing cumulative heating, melt formation in the silicon substrate, delamination, and burr—critical defects when substrates are thinned below 50 µm. The fundamental problem: low-κ materials are largely transparent, so laser energy penetrates through the stack and is absorbed in the substrate rather than the target layer. This thesis explores a novel dual-pulse approach: a femtosecond DUV pulse (257 nm) transiently generates free carriers in a thin near-surface zone of the low-κ material, making it absorbing for a subsequent 515 nm fs-pulse. This enables controlled, substrate-preserving, athermal layer removal—confining energy deposition exactly where it is needed. Be part of change You will review literature on laser–material interaction in nanoporous low-κ dielectrics Afterwards, you will set up and align the the dual-pulse optical arrangement (DUV pump + 515 nm ablation pulse) You will also be responsible for the pump-probe characterisation of transient optical properties after DUV excitation Through experiments, you will investigate the dual-pulse ablation in low-κ/Si layer systems The objectives of the project will be tailored to your skills and preferences

Before you apply

0 of 4 ready

A preparation checklist, saved in this browser on this device without an account. It does not sync across devices. The official posting determines eligibility and required documents.

CV, motivation letter, and supervisor email templates

How to apply

Apply via jobs.fraunhofer.de. Check the original listing for required documents and submission instructions.

Source and listing information

Application source: jobs.fraunhofer.de. Listing details may change; confirm them on the source site. A source check confirms page availability, not endorsement of the organization.

Report an outdated or incorrect listing

Explore similar theses and internships

More opportunities

Browse all theses and internships